Skip to main content

Appraisal number: 848 (2019)

Date issued: 23 May 2019

BGC Stratum™ Contour Cavity Cladding System

Description

The BGC Stratum™ Contour Cavity Cladding System is a cavity-based external wall cladding system. It is designed to be used as an external wall cladding system for residential and light commercial type buildings where domestic construction techniques are used.

The BGC Stratum™ Contour Cavity Cladding System consists of Stratum™ Contour fibre-cement planks fixed over timber battens to form a cavity. The fibre-cement planks are finished with a paint system.

The system incorporates a primary and secondary means of weather resistance (first and second line of defence) against water penetration by separating the cladding from the external wall framing with a nominal 20 mm cavity.

Scope

The BGC Stratum™ Contour Cavity Cladding System has been appraised as an external wall cladding system for buildings within the following scope:

  • The scope limitations of NZBC Acceptable Solution E2/AS1 paragraph 1.1.
  • Constructed with timber framing complying with the NZBC.
  • With a risk score of 0-20 calculated in accordance with NZBC Acceptable Solution E2/AS1 Table 2.
  • Situated in NZS 3604 wind zones up to and including extra high.

The BGC Stratum™ Contour Cavity Cladding System has also been appraised for weathertightness and structural wind loading when used as an external wall cladding system for buildings within the following scope:

  • The scope limitations of NZBC Acceptable Solution E2/AS1 paragraph 1.1 with regard to building height and floor plan area.
  • Constructed with timber framing complying with the NZBC.
  • Situated in specific design wind pressures up to a maximum design differential ultimate limit state (ULS) of 2.5 kPa.

The BGC Stratum™ Contour Cavity Cladding System must only be installed horizontally on vertical surfaces.

The BGC Stratum™ Contour Cavity Cladding System has been appraised for use with aluminium window and door joinery that is installed with vertical jambs and horizontal heads and sills. (The Appraisal of the BGC Stratum™ Contour Cavity Cladding System relies on the joinery meeting the requirements of NZS 4211 for the relevant wind zone or wind pressure.)

Technical literature

  • BGC Stratum Contour Architectural Drawings STC-01 to STC-30, January 2014
  • Stratum™, Stratum™ Duo, Stratum™ Trio - Horizontal and Vertical Installation, Stratum™ Contour, September 2019

Consenting instructions

Always refer to the Appraisal in full and the technical literature.

Appraisal holder

BGC (Australia) Pty Ltd T/A BGC Fibre Cement
Address:
Phone: 0800 424 234
Email: nz@bgc.com.au

Marketer details

Address:
Phone:
Web:
Email: